GameCube Controller
From HwB
(Difference between revisions)
| Line 34: | Line 34: | ||
== Source == | == Source == | ||
* [http://www.int03.co.uk/crema/hardware/gamecube/gc-control.htm Nintendo Gamecube Controller Protocol] | * [http://www.int03.co.uk/crema/hardware/gamecube/gc-control.htm Nintendo Gamecube Controller Protocol] | ||
| + | |||
| + | [[Category:Connector]] | ||
Revision as of 12:55, 30 December 2006
| Todo: This page needs some editing. |
Available at Nintendo GameCube.
Pinout
_7_ /123\ |456| \---/ (female at the console)
| Pin | Colour | J1 | Function |
|---|---|---|---|
| 1 | Yellow | 2 | 5V power supply (used by rumble motor). |
| 2 | Red | 3 | DATA line: bi-directional data to/from console, pull-up to 3.43V |
| 3 | Green | 4 | Ground. |
| 4 | White | 5 | Ground (Skillz interface has pins 3+4 wired as common ground). |
| 5 | - | - | Unknown: not connected by official controller, or Skillz interface. |
| 6 | Blue | 1 | 3.43V logic supply. |
| 7 | Black n | 6 | Cable shielding / ground. Usually common ground with pin 3. |
J1: Pinout of the connector inside the controller